金牛区环氧地坪公司分析刷痕的起因及处理
环氧地坪刷痕产生的原因：

A、涂料本身的原因：主要是涂料的流平性差，涂料的粘渡过高；有触变性的填料或助剂。

B、施工原因：施工方法错误，涂料搅拌后施工时间过长，滚筒表面处理有误，涂层过薄。

解决的方法：

A、涂料的原因，增加涂料的流杭州防水汕头兴达空调维修公司188134186-28平性，降低涂料的粘度，尽可能减少有触变性的填料和助剂，特别要留意墙面涂料的流平剂用在地坪涂料的现象。

B、环氧地坪留意施工方法，涂料的熟化时间不要过长。滚筒的二端到圆角，涂层的一遍厚度尽可能不要小于0.15mm。

The causes of brush mark:
A, the cause of the coating itself: mainly poor flowing property of paint, coating glue through high; Packing or thixotropic agent.
B, construction: construction method error, coating construction time is too long, after mixing drum surface treatment is wrong, a thin coating.
Solution: A, coating, increase the coating flow property, lower the viscosity of the coating, minimize the thixotropy of fillers and additives, especially to pay more attention to metope paint flow ping agent used in floor coating. B, pay attention to construction method, coating curing time not too long. The two end of the cylinder to the rounded corners, coating thickness again as far as possible, not less than 0.15 mm.